Contents: Removal and installation the oil…⬇ Removal and installation the low oil…⬇ Removal and installation oil…⬇
Removal and installation the oil pressure sensor "F22"
Disconnect the "arrow" connector from the oil pressure sensor "F22". Unscrew the oil pressure sensor "F22" "1".
Installation
Installation in reverse order.
Note: Replace the sealing ring. To avoid loss of engine oil, immediately push the new oil pressure sensor "F22" into the hole.
Check the oil level.
Removal and installation the low oil pressure sensor "F378"
Disconnect the "arrow" connector of the low oil pressure sensor "F378". Unscrew the low oil pressure sensor "F378" "1".
Installation
Installation in reverse order.
Note: Replace the sealing ring. To avoid loss of engine oil, immediately push the new low oil pressure sensor "F378" into the hole.
Check the oil level.
Removal and installation oil pressure sensor, step 3 "F447"
Remove the noise-insulating casing. Remove the air filter housing. Loosen the clamp "arrow" and remove the air hose "1" from the intercooler.
Release the wire harnesses "1" and "2" secured to the air duct. Loosen the clamp "3". Unscrew the screws "arrows" and remove the air duct by moving it downwards.
(Data copied from the portal: www.SKODABOOK.ru)
Disconnect connector "1" from oil pressure sensor, stage 3 "F447". Unscrew the "arrow" screws and remove the toothed belt cover. Unscrew the oil pressure sensor, stage 3 "F447" "2" using the articulated key "T40175".
Installation
Installation in reverse order.
Note: Replace the sealing ring. To avoid loss of engine oil, immediately push the new oil pressure sensor, stage 3 "F447" into the bore.
Check the engine oil level.