Important: If you replace the bumper, you must glue new sensor holders into the new bumper, the visible part of which is painted with varnish in the color of the bumper. The internal and external sensor holders are not the same. Before applying the holders, clean and degrease the contact area on the bumper and apply 3M plastprimer 4298UV activator. When replacing sensors, paint the visible part of the sensors with a varnish that matches the bumper color.
Remove the rear bumper. Press the retaining clips on the "arrow" sensor holder. Push the sensor from the outside of the bumper inward. Disconnect the plug connector.
Installation is carried out in the reverse order of actions.
[Material is available on the website: skodabook]