Contents: Removal ⬇ Installation ⬇
Removal
1. Remove the dust boots (2) by squeezing the clips (arrow) and detaching the dust boot from the front body pillar, as shown in the figure below
2. Move the lever (3) downwards (arrow b) and disconnect the wiring harness connector (4) shown in the figure below.
3. Loosen the fastening screws (7) on the hinges (arrow d), as shown in the figure below.
4. Unscrew the fastening screws (5) of the front door travel limiter assembly (6), as shown in the figure below.
5. Move the door (1) upwards (arrow e) and remove it from the hinges (8), as shown in the figure below.
Installation
1. Installation is carried out in the reverse order of removal.
2. Tighten the mounting screws (7) shown in the figure above with a tightening torque of 21.5 Nm.
Material is available on the website SKODABOOK
3. Tighten the mounting screws (5) shown in the figure above with a tightening torque of 30 Nm.
4. Check the uniformity of the gap between the door and the doorway; if necessary, adjust the position of the front door.