Contents: Removal ⬇ Installation ⬇
Note: Before removing the head unit, you must remove the CD from the head unit, if installed.
Removal
1. Turn off the audio system module and all power consumers. Remove the key from the ignition switch.
2. Using the special tool (3409), carefully detach and remove the decorative frame of the head audio module (1), as shown in the figure below.
Radio Swing
3. Using the special tool (3409), detach the upper part and remove the decorative panel of the head audio module trim (1), as shown in the figure below.
4. Unscrew the mounting screws (arrows) and pull the head module of the audio system out of the dashboard, as shown in the figure below. The tightening torque of the mounting screws during installation is 1.5 Nm.
For all modifications
5. Compress the connector clamps (arrows) as shown in the figure below.
[Data taken from this portal: SkodaBook.ru]
6. Open the retainer clamp (arrow) and disconnect the wiring harness connector as shown in the figure below.
Radio Blues
7. Release the antenna connector clamp (arrow), then disconnect the wiring harness connector as shown in the figure below.
Radio Swing
8. Unlock the antenna connector clamp (arrow), then disconnect the wiring harness connector as shown in the figure below.
Installation
Installation is carried out in the reverse order of removal.
Note: If the audio module has been replaced with a new one, you will need to enter the security code.