Power system — appearance (1.2L MPI engine) (Skoda Rapid NH1)

1. Vacuum control valve (forced exhaust gas recirculation system PCV)
2. Fuel injectors
3. Solenoid valve 1 of the activated carbon tank
4. Engine speed sensor
5. Intake manifold air pressure sensor and intake air temperature sensor
6. Throttle body module assembly
7. Coolant temperature sensor
8. Electronic engine control unit
9. 4-pin connector
10. Wiring harness connector
11. Knock sensor 1
12. Lambda sensor
13. Ignition coils with output power stage
14. Camshaft position sensor
15. Ground wire attachment point
16. Container with activated carbon

1. Connecting pipe of the intake system
2. Open type fastening clamp
3. Air filter housing assembly
4. Intake manifold assembly
5. Cable duct
6. Engine oil level and temperature sensor wiring harness connector
7. Fuel injector wiring harness connectors
8. Connecting the fuel supply hose
9. Fuel rail mounting bolts, tightening torque during installation 8 Nm
10. Fuel rail assembly with fuel injectors
11. Ventilation valve
12. Exhaust manifold mounting bolts, tightening torque during installation 20 Nm
13. Intake manifold assembly
14. Upper lambda sensor of the exhaust system
15. Lambda sensor wiring harness connector
16. Lower lambda sensor of the exhaust system
17. Lambda sensor wiring harness connector
18. Cooling system temperature sensor
19. Sealing ring
20. Retaining ring
21. Fastening bolt, tightening torque during installation 8 Nm
22. Regulator body (thermostat) engine cooling systems
23. Retaining ring
24. 81- and 40-pin connector
25. Electronic engine control unit
26. Support
27. Fastening screws, tightening torque during installation 2 Nm

1. Valve for removing air from the fuel system
2. Fuel rail
3. Sealing ring
4. Fuel injector
5. Locking clamp
6. The right line
7. Fuel rail mounting screws, tightening torque during installation 10 Nm