10.1. Removing the side deflector.
2. Central deflectors (see illustration) are removed in the same way as the side ones (see paragraph 1), but after pulling them out, you should additionally disconnect the connectors of the SRS indicator lamp and the hazard warning switch.
10.2. Removing the central deflectors.
3. To remove the deflectors in the rear part of the center console, carefully pry them up with a plastic wedge No. 3409 at the fixing points (see illustration).
10.3. Fixing points for rear central deflectors.
4. To remove the air duct (1 in the illustration) to the left footwell, remove the lower part of the instrument cluster and the left instrument panel trim (see Chapter 11), remove the driver's knee airbag together with the bracket (see Chapter 12) and unscrew the screw (2).
10.4. Fastening the air duct to the left foot well.
5. To remove the air duct (1 in the illustration) to the right footwell, remove the main storage box (see Chapter 11) and remove the screw (2). On models with a cooled glove box, pay attention to the correct position of the air hose when installing.
10.5. Fastening the air duct to the right foot well.
6. To remove the air ducts to the rear footwells, remove the appropriate front seat, center console, and front floor covering connections (see Chapter 11). Lift the floor covering, unhook the air duct from the body and pull it out of the climate control system housing (see illustration). When installing the air duct, first secure it to the air conditioning system housing.
10.6. Removing the air duct to the rear left footwell.
7. To remove the air intake grille, remove the windshield fairing grille (see Chapter 11), disconnect the connector or remove the air quality sensor "G238" (if available, see Section 14), give me the nuts (see illustration) and pull the grille up. When installing, make sure that the gasket is positioned correctly on the grille. Tighten the nuts with a force of 2.5 Nm.
10.7. Fastening the air intake grille.