Connecting blocks of the sensor of inclusion of the fan and the electric motor of the fan
1 - connecting block of the fan switch-on sensor; 2 - connecting block of the fan electric motor; 3 – a tip of a taking away hose of a radiator; 4 - tip lock
1. Disconnect the wire from the terminal «-» battery.
2. Drain the coolant (see subsection 5.13).
3. By pressing the tabs of the latches, disconnect the blocks 1 and 2 with wires from the fan switch-on sensor and the fan motor (see fig. Connecting blocks of the sensor of inclusion of the fan and the electric motor of the fan).
4. Having pressed the spring clamp 4, disconnect the outlet from the radiator pipe (lower) hose with a tip 3. Disconnect the inlet hose from the radiator in the same way.
5. Remove the front buffer.
6. Remove the frame of the engine compartment assembly with the radiator (see subsection 11.1).
7. Turn away bolts of fastening and remove a radiator in gathering with a casing 7 (see fig. Radiator of the cooling system) fan.
8. If necessary, unscrew screws 8 and remove casing 7 from radiator 1.
9. Replace torn or loose O-rings 2.
10. Install the radiator in reverse order. At the same time, please note that the upper supports 19 of the radiator are white, and the lower 17 are black.
11. Fill with coolant after installation. The moment of an inhaling of bolts of fastening of a radiator of 5 Н·м.