2. Drain the coolant (see subsection 5.13).
3. Press the retaining tabs and disconnect connectors 1 and 2 with wires from the fan switch sensor and fan motor, as well as from the additional fan motor (see figure Connecting blocks of the fan switch sensor and the fan motor).
4. After removing spring retainer 4, disconnect the outlet (lower) hose with tip 3 from the radiator pipe. In the same way, disconnect the supply hose from the radiator.
Caution! Do not open the air conditioning system, i.e., do not disconnect the hoses from the condenser.
5. Remove the engine compartment frame (see subsection 11.1), securing the radiator with the condenser to the body. Make sure that the condenser hoses are not kinked excessively.
Caution! Never leave the radiator with the condenser hanging by its hoses.
6. Unscrew the four bolts 2 securing the condenser 3 to the radiator 1.
7.Remove the radiator 1 from the vehicle (see figureRadiator of the cooling system) assembled with a fan.
8. If necessary, unscrew screws 8 and remove casing 7 from radiator 1.
9. Replace any torn or loose sealing rings.
(Data copied from the portal: skodabook.ru)
10. Install the radiator in reverse order. Please note that the upper radiator supports are white and the lower ones are black.
11. After installation, fill with coolant.
Tightening torques, Nm
| Radiator mounting bolts | 5 |
| Bolts for fastening the condenser to the radiator | 5 |