Contents: Cars with radiator version 1 ⬇ Cars with cooling radiator versions…⬇ All ⬇ Cars with radiator version 1 ⬇ Cars with cooling radiator versions…⬇ Cars with radiator version 3 ⬇ Installation ⬇
Warning! Risk of injury due to sudden automatic activation of the radiator fan. Before starting work in the area of the fan frame, disconnect the electrical connectors. Depending on the vehicle version, 3 radiator versions are installed.
Drain the coolant. Remove the fan shroud. Remove the front bumper.
Cars with radiator version 1
Lift the clamp "arrow" and disconnect the right upper hose from the charge air cooling circuit radiator.
Cars with cooling radiator versions 2 and 3
Lift the bracket "1" and disconnect the right upper coolant hose from the coolant radiator, (the right lower coolant hose is already disconnected).
All
Lift the clamp "arrow" and disconnect the upper left coolant hose from the radiator.
Simultaneously press both "arrow" locks of the radiator support, for example, with screwdrivers, and remove the support from the fasteners on both sides. Tilt the radiator towards the passenger compartment.
Note: If the fastening is broken, the upper radiator support "1" does not need to be replaced. Replace the fastening with a special screw "3".
Unlock the clamps on the right and left of the radiator "1" "arrow A" and lift the condenser. Press the radiator down until the lower support is compressed and hang the condenser "2" from the radiator "1". Tie the condenser to the front support panel.
Cars with radiator version 1
Remove the radiator together with the intercooler from the car. Press the radiator clamps "arrow" on the left and right at the same time and release the coolant and supercharged air cooling radiators.
Cars with cooling radiator versions 2 and 3
Remove the coolant radiator together with the intercooler from the car.
Original text is located on: skodabook.ru
Cars with radiator version 3
Disconnect the fasteners of the charge air cooling circuit "1" "arrow A" from the coolant radiator "2". Tilt the charge air radiator "1" in the "direction of arrow B" and release in the -direction of arrow C-.
Installation
Installation in reverse order.
Note: Replace the sealing rings.
Install the front bumper. Install the fan shroud. Connect the coolant hoses with a quick-release coupling. Fill with coolant.
Note: After replacing the radiator, all coolant must be replaced.