Electrical power devices of car Skoda Kodiaq 1
Starter — components
Components 1. Starter assembly; 2. Fastening stud, tightening torque 80 Nm; 3. The "mass" wire; 4. Fastening nut, tightening torque 20 Nm; 5. Wiring harness connector; 6. Fastening nut, tightening torque 20 Nm; 7. Lid;...
Components 1. Starter assembly; 2. Fastening stud, tightening torque 80 Nm; 3. The "mass" wire; 4. Fastening nut, tightening torque 20 Nm; 5. Wiring harness connector; 6. Fastening nut, tightening torque 20 Nm; 7. Lid;...
Starter — description
The starter has poles located around the armature. Both solenoid windings are energized. The pull-in winding is connected to ground through the starter. The windings of the pull-in circuit together create an...
The starter has poles located around the armature. Both solenoid windings are energized. The pull-in winding is connected to ground through the starter. The windings of the pull-in circuit together create an...
Removal and installation the starter
Removal 1. Disconnect the negative terminal from the battery. 2. Remove the soundproofing coating. 3. Remove the air filter housing above the front of the battery (for more details, see the relevant section in the...
Removal 1. Disconnect the negative terminal from the battery. 2. Remove the soundproofing coating. 3. Remove the air filter housing above the front of the battery (for more details, see the relevant section in the...
Removal and installation the starter (7-speed manual transmission)
Removal 1. Disconnect the negative terminal from the battery. 2. Remove the air filter housing assembly (for more details, see the corresponding section in the chapter " Intake and exhaust system "). 3. Unscrew the...
Removal 1. Disconnect the negative terminal from the battery. 2. Remove the air filter housing assembly (for more details, see the corresponding section in the chapter " Intake and exhaust system "). 3. Unscrew the...
General procedures for checking the technical condition of the starter
Note: Below is a summary of the data on checking the technical condition of starters of starting systems. Checking the operation of the pull-in and holding windings. Attention: To prevent the winding from burning out,...
Note: Below is a summary of the data on checking the technical condition of starters of starting systems. Checking the operation of the pull-in and holding windings. Attention: To prevent the winding from burning out,...
Generator — components
Components 1. Generator assembly; 2. Mounting bolts, tightening torque during installation: 23 Nm; 3. Bushings; 4. Connector; 5. Lid; 6. Fastening nut, installation tightening torque: 20 Nm; 7. Terminal 30/B+; 8....
Components 1. Generator assembly; 2. Mounting bolts, tightening torque during installation: 23 Nm; 3. Bushings; 4. Connector; 5. Lid; 6. Fastening nut, installation tightening torque: 20 Nm; 7. Terminal 30/B+; 8....
Generator — removal and installation
Removal 1. Disconnect the negative terminal from the battery. 2. Remove the accessory drive belt (for more details, see the corresponding section in the chapter " Gasoline / Diesel " engines). Models with diesel engines...
Removal 1. Disconnect the negative terminal from the battery. 2. Remove the accessory drive belt (for more details, see the corresponding section in the chapter " Gasoline / Diesel " engines). Models with diesel engines...
General procedures for checking the technical condition of charging systems
Attention: Check that the battery cables are connected to the terminals. Never disconnect the battery cables while the engine is running. Please note: Depending on the year of manufacture, different readings may be...
Attention: Check that the battery cables are connected to the terminals. Never disconnect the battery cables while the engine is running. Please note: Depending on the year of manufacture, different readings may be...
Checking the technical condition of the generator after disassembly
Checking the rotor 1. Check the rotor winding for damage. Check the resistance between the generator rings. If the resistance is low, then there is a short circuit in the rotor (short circuit). If there is no...
Checking the rotor 1. Check the rotor winding for damage. Check the resistance between the generator rings. If the resistance is low, then there is a short circuit in the rotor (short circuit). If there is no...
Rechargeable battery
Disconnecting the battery Note: Before disconnecting the battery, you should find out the code for your car's radio and navigation system, respectively. This does not apply to factory-installed radios and navigation...
Disconnecting the battery Note: Before disconnecting the battery, you should find out the code for your car's radio and navigation system, respectively. This does not apply to factory-installed radios and navigation...
Possible malfunctions and how to fix them
Malfunction Cause Solution Low voltage in the vehicle's on-board network at the rated engine crankshaft speed. The alternator drive belt tension is loose. Tension the alternator drive belt according to the operating...
Malfunction Cause Solution Low voltage in the vehicle's on-board network at the rated engine crankshaft speed. The alternator drive belt tension is loose. Tension the alternator drive belt according to the operating...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Read similar sections on other Skoda models
➧ Electrical equipment: Power devices Skoda Fabia 2 (2007-2014)
➧ Electrical equipment: Power devices Skoda Rapid 1 (2012-2022)
➧ Electrical equipment: Power devices Skoda Favorit (1987-1994)
Link to this section in various formats
TEXTHTMLBB Code
- General information
- User manual
- Controls and instruments
- Maintenance
- Power unit
- Petrol engine 1.4 l
- Petrol engine 2.0 l
- Diesel engine 2.0 l
- Fuel and control (petrol)
- Fuel and control (diesel)
- Cooling system (petrol 1.4 l)
- Cooling system (petrol 2.0 l)
- Cooling system (diesel 2.0 l)
- Lubrication system (petrol)
- Lubrication system (diesel)
- Intake and exhaust (petrol 1.4 l)
- Intake and exhaust (petrol 2.0 l)
- Intake and exhaust (diesel 2.0 l)
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Drive shafts
- Chassis (running gear)
- Front suspension
- Rear suspension
- Wheels and tires
- Brake system
- Steering system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heating and air conditioning
- Security systems
- Electrical equipment
- Power devices
- Equipment and devices
- Electrical circuits
- Electrical circuits (petrol 2.0 l)
- Electrical circuits (halogen headlights)
- Electrical circuits (LED headlights)
- Electrical circuits (Climatronic)

