Engine lubrication system (diesel) of vehicle Skoda Kodiaq 1
Diesel engines — components
Components 1. Fastening screw, tightening torque during installation 8 Nm; 2. Engine oil temperature and level sensor; 3. Sealing ring; 4. Drain plug, tightening torque during installation 30 Nm; 5. Sealing ring; 6....
Components 1. Fastening screw, tightening torque during installation 8 Nm; 2. Engine oil temperature and level sensor; 3. Sealing ring; 4. Drain plug, tightening torque during installation 30 Nm; 5. Sealing ring; 6....
Oil pan — removal and installation
Removal Note: Drain the engine oil first. 1. Disconnect the wiring harness connector (arrow) from the engine oil level and temperature sensor as shown in the figure below. 2. Release the fastening clamps (arrows) and...
Removal Note: Drain the engine oil first. 1. Disconnect the wiring harness connector (arrow) from the engine oil level and temperature sensor as shown in the figure below. 2. Release the fastening clamps (arrows) and...
Lower part of the cylinder block crankcase — removal and installation
Removal 1. Remove the soundproofing coating. 2. Remove the front right wheel arch liner (for more details, see the corresponding section in the chapter " Body "). 3. Remove the soundproofing covering from the oil pan....
Removal 1. Remove the soundproofing coating. 2. Remove the front right wheel arch liner (for more details, see the corresponding section in the chapter " Body "). 3. Remove the soundproofing covering from the oil pan....
Oil pump — removal and installation
Removal 1. Remove the oil pan assembly ( for more details, see the relevant section in this chapter ). Caution: Be extremely careful not to damage the timing belt. 2. Unscrew the mounting screws (arrows) shown in the...
Removal 1. Remove the oil pan assembly ( for more details, see the relevant section in this chapter ). Caution: Be extremely careful not to damage the timing belt. 2. Unscrew the mounting screws (arrows) shown in the...
Engine oil level and temperature sensor — removal and installation
Removal 1. Disconnect the wiring harness connector (arrow) from the engine oil temperature and level sensor as shown in the figure below. 2. Disconnect the mounting clamps (arrows), then remove the soundproofing cover...
Removal 1. Disconnect the wiring harness connector (arrow) from the engine oil temperature and level sensor as shown in the figure below. 2. Disconnect the mounting clamps (arrows), then remove the soundproofing cover...
Oil filter with holder
General appearance 1. Drain plug; 2. Sealing ring; 3. Oil filter cover, installation tightening torque 25 Nm; 4. Sealing ring; 5. Oil filter element; 6. Sealing ring; 7. Engine oil pressure sensor, tightening torque of...
General appearance 1. Drain plug; 2. Sealing ring; 3. Oil filter cover, installation tightening torque 25 Nm; 4. Sealing ring; 5. Oil filter element; 6. Sealing ring; 7. Engine oil pressure sensor, tightening torque of...
Engine oil pressure sensor for the pressure reduction line — removal and installation
Removal 1. Remove the air filter housing assembly (for more details, see the relevant section in the chapter " Intake and exhaust system "). 2. Disconnect the wiring harness connector (arrow) shown in the figure below....
Removal 1. Remove the air filter housing assembly (for more details, see the relevant section in the chapter " Intake and exhaust system "). 2. Disconnect the wiring harness connector (arrow) shown in the figure below....
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Read similar sections on other Skoda models
➧ Power unit: Lubrication system Skoda Fabia 1 (1999-2007)
➧ Power unit: Lubrication system Skoda Rapid 1 (2012-2022)
Link to this section in various formats
TEXTHTMLBB Code
- General information
- User manual
- Controls and instruments
- Maintenance
- Power unit
- Petrol engine 1.4 l
- Petrol engine 2.0 l
- Diesel engine 2.0 l
- Fuel and control (petrol)
- Fuel and control (diesel)
- Cooling system (petrol 1.4 l)
- Cooling system (petrol 2.0 l)
- Cooling system (diesel 2.0 l)
- Lubrication system (petrol)
- Lubrication system (diesel)
- Intake and exhaust (petrol 1.4 l)
- Intake and exhaust (petrol 2.0 l)
- Intake and exhaust (diesel 2.0 l)
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Drive shafts
- Chassis (running gear)
- Front suspension
- Rear suspension
- Wheels and tires
- Brake system
- Steering system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heating and air conditioning
- Security systems
- Electrical equipment
- Power devices
- Equipment and devices
- Electrical circuits
- Electrical circuits (petrol 2.0 l)
- Electrical circuits (halogen headlights)
- Electrical circuits (LED headlights)
- Electrical circuits (Climatronic)
