Intake and exhaust system (petrol 1.4) of car Skoda Kodiaq 1

Air filter — removal and installation
Components 1. Lower part of the air intake; 2. Upper air intake pipe; 3. Lid; 4. Fastening screw, tightening torque 2 Nm; 5. Lower part of the air filter housing; 6. Filter element; 7. Upper part of the air filter...

Intake manifold — removal and installation
Removal 1. Remove the air filter housing assembly ( for more details, see the relevant section in this chapter ). 2. Remove the soundproofing covering from the engine compartment. 3. Drain the coolant into a...

Elements of the exhaust system
Installation position of the mounting clamp Install the hose clamp in the position shown in the figure below. Angle α = approximately 20° The tie bolt should be on the right side. The mounting nut should be on top.

Catalytic converter assembly with exhaust pipe — removal and installation
Removal Note: All disconnected wiring harnesses and hoses must be reconnected to their original positions. 1. Disconnect the wiring harness connectors (1) and (2) from the holder, then disconnect the wiring harness...

Turbocharger — general view
General appearance 1. Turbocharger assembly; 2. Fastening screw, tightening torque during installation 8 Nm; 3. Supports; 4. Sealing ring; 5. Gasket; 6. Thermal insulation coating; 7. Mounting bolt, tightening torque...

Turbocharger assembly — removal and installation
Removal Note: All removed thermal insulation coating elements must be returned to their original position during installation. Please note: If mechanical damage to the turbocharger is detected, it may not be the only...

Boost pressure regulator — removal and installation
Removal 1. Turn off the ignition. 2. Disconnect the wiring harness connector (1) shown in the figure below. 3. Remove the lock washer (2) using the special puller (T40265) as shown in the figure below. 4. Unscrew the...

Boost Pressure Sensor/Intake Air Temperature Sensor — removal and installation
Removal 1. Disconnect the wiring harness connector (1) shown in the figure below. 2. Unlock the fasteners (arrows) and remove the boost pressure sensor/intake air temperature sensor 2 as shown in the figure below....

Intercooler — removal and installation
Removal 1. Disconnect the wiring harness connector (1) shown in the figure below. 2. Unscrew the mounting bolts and remove the air conditioning compressor (arrows) from the mounting bracket without disconnecting the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Power unit: Exhaust system Skoda Fabia 1 (1999-2007)
➧ Power unit: Intake and exhaust system Skoda Rapid 1 (2012-2022)
➧ Power unit: Exhaust system Skoda Octavia 1 (1996-2004)
➧ Power unit: Exhaust system Skoda Yeti (2009-2017)

Link to this section in various formats

TEXTHTMLBB Code

Kodiaq 1 (2016-2024)