Rear suspension of car Skoda Kodiaq 1

Setting the rear axle suspension to a position corresponding to the vehicle's curb weight
Note: Necessary tools, measuring instruments and auxiliary equipment Jack for engines and transmission units "VAG 1383A". Fastening belt "T10038". Fastening "T10149". Note: All bolts on silent block components must be...

Rear suspension components
Rear suspension components 1. Washer; 2. Nut; 3. Upper wishbone; 4. Washer; 5. Fastening bolt, tightening torque 130 Nm + 180 degrees; 6. Rear wheel hub housing; 7. Fastening nut; 8. Rivet; 9. Fastening bolt, tightening...

Removal and installation the upper control arm
Removal 1. Unscrew the wheel bolts. 2. Raise the car. 3. Remove the coil spring ( for more details, see the relevant section in this chapter ). 4. Unscrew the fastening nut (1) and remove it together with the washer...

Lower wishbone — removal and installation
Removal 1. Loosen the rear wheel mounting bolts. 2. Raise the car on a lift. Check and make sure that it is securely fixed to the lift supports. 3. Remove the rear wheel completely. 4. Unscrew the mounting screws (1)...

Rear suspension link assembly — removal and installation
1. Mark the rear suspension height "a". 2. Remove the rear wheel. 3. Remove the mounting bolts (arrow) of the anti-roll bar bracket (1) on both sides of the vehicle, as shown in the figure below. 4. Loosen the fastening...

Rear shock absorber — removal and installation
Removal 1. Remove the rear wheel assembly. 2. Using special mounting tapes "T10038", fix the car on the lift supports, as shown in the figure below. 3. Remove the rear wheel arch liner (for more details, see the...

Removal and installation the wheel hub bearing unit
Note: Necessary tools, measuring instruments and auxiliary equipment Cap remover "VW637/2". Mandrel "3241" Torque wrench "VAG 1332". Torque wrench "VAG 1410" Socket wrench "T10162". Removal 1. Unscrew the wheel bolts....

Removal and installation a coil spring
Removal 1. Unscrew the wheel bolts. 2. Raise the car. 3. Remove the wheel. 4. Compress the petals (arrows) of the guide assembly (1) as shown in the figure below. 5. Remove the guide (1). 6. Install the suspension...

Removal and installation the rear wheel axle
Removal 1. Loosen the nut securing the drive shaft to the rear wheel hub. Attention: After loosening the hub nut, remove any load from the hub bearings. Otherwise, the weight of the vehicle will damage the wheel...

Rear suspension trailing arm
Removal and installation 1. Remove the rear wheel assembly. 2. Disconnect the line (1) from the rear suspension trailing arm (2). To do this, remove the clips from the holes in the arm, as shown in the figure below. 3....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Read similar sections on other Skoda models

➧ Chassis (running gear): Rear suspension Skoda Fabia 1 (1999-2007)
➧ Chassis (running gear): Rear suspension Skoda Rapid 1 (2012-2022)
➧ Chassis (running gear): Rear suspension Skoda Octavia 3 (2013-2019)
➧ Chassis (running gear): Rear suspension Skoda Superb 2 (2008-2015)
➧ Chassis (running gear): Rear suspension Skoda Yeti (2009-2017)

Link to this section in various formats

TEXTHTMLBB Code

Kodiaq 1 (2016-2024)