Attention! The glass cover drive of the lifting hatch may only be removed and installed when the hatch is closed (zero position). Conditions for removing/installing the drive: Engine and ignition are turned off, ignition key is pulled out, door is open.
Remove the lighting unit/front control panel. Unscrew the screws "3". Lower the sliding sunroof motor "1" slightly and tilt it back. Disconnect the connector "4".
Installation
Install the sliding sunroof motor "1" and screw in the screws "2". Tightening torque - 3.5 Nm. Connect the connector "4". Install the lighting unit/front control panel. After completing all work, perform an installation run of the sliding sunroof motor.