Fabia Rapid Octavia Superb Kodiaq Yeti Others

Octavia 1 (1996-2004) Octavia 3 (2013-2019)

Removal and installation the rear left ground clearance sensor «G76» — front-wheel drive vehicles (Skoda Octavia 5E)

0

Disconnect connector "1". Unscrew bolts "2" and "3". Remove the ground clearance sensor of the car "G76".

Disconnect connector «1». Unscrew bolts «2» and…

Installation

Installation in reverse order.

Note: The vehicle's ride height sensor lever must point toward the outside of the vehicle.

Perform basic headlight installation.

Material is available on the website: SKODABOOK.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

Skoda Octavia 3: Rear suspension

Details and assemblies of the rear left ground clearance sensor «G76» —…
Parts and assemblies of the rear left ground clearance sensor «G76» —…
Removal and installation the trailing arm with support bracket
General installation diagram: rear axle transverse traction — all-wheel…
Removal and installation the rear axle toe-in rod — front-wheel drive…

Removal and installation the rear left ground clearance sensor «G76» —…
Drive shaft — design description
Drive shaft — tightening torques
Removal and installation the drive shaft

Read similar articles on other Skoda models

➧ Removal and installation the front wheel drive Skoda Fabia 1 (1999-2007)
➧ Rear Wheel Pin — Removal and Installation Skoda Rapid 1 (2012-2022)
➧ Removal and installation the front suspension height sensor Skoda Superb 2 (2008-2015)
➧ Front wheel speed sensor Skoda Kodiaq 1 (2016-2024)
➧ Drive shafts and wheel hubs — specifications Skoda Yeti (2009-2017)
➧ Checking and adjusting the clearance in the throttle drive mechanism Skoda Felicia (1994-2001)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors

No comments yet

Octavia 3 (2013-2019)

By continuing to use the site, you agree to the use of cookies.