Parts and assemblies of the rear left ground clearance sensor «G76» — vehicles with front-wheel drive (Skoda Octavia 5E)

Note: The ride height sensor is supplied as a spare part only complete with connecting rod and lower and upper mounting bracket.

1. Bolt, 5 Nm

2. Rear left ground clearance sensor "G76": complete with mounting parts; the lever should be directed towards the outside of the car

3. Threaded rivet

4. Connector

5. Threaded rivet

6. Bolt, 5 Nm

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

◀ Previous

Skoda Octavia 3: Rear suspension

Next ►

Removal and installation the trailing arm with support bracket
General installation diagram: rear axle transverse traction — all-wheel…
Removal and installation the rear axle toe-in rod — front-wheel drive…
General installation diagram: rear axle transverse tie rod — front-wheel…
Removal and installation the lower wishbone — all-wheel drive vehicles

Details and assemblies of the rear left ground clearance sensor «G76» —…
Removal and installation the rear left ground clearance sensor «G76» —…
Removal and installation the rear left ground clearance sensor «G76» —…
Drive shaft — design description
Drive shaft — tightening torques

Read similar articles on other Skoda models

➧ Removal and installation the front wheel drive Skoda Fabia 1 (1999-2007)
➧ Rear Wheel Pin — Removal and Installation Skoda Rapid 1 (2012-2022)
➧ Removal and installation the front suspension height sensor Skoda Superb 2 (2008-2015)
➧ Front wheel speed sensor Skoda Kodiaq 1 (2016-2024)
➧ Drive shafts and wheel hubs — specifications Skoda Yeti (2009-2017)
➧ Removal and installation front wheel hub assemblies Skoda Felicia (1994-2001)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors

No comments yet

Octavia 3 (2013-2019)