Cars with ground clearance sensor "G76"
Disconnect connector "1". Unscrew screws "2". Remove ground clearance sensor "G76" "3" from the transverse arm.
All
Remove the stabilizer. Unscrew the lower shock absorber support mounting bolt 2. Unscrew the lower steering knuckle mounting bolt "4".
The original article is available on (www.skodabook.ru)
Unscrew bolt "1" securing stabilizer bar "2". Unscrew the drive shaft from the rear main gear flange. Slightly tilt the steering knuckle back and disconnect the drive shaft from the rear main gear flange. Tilt the drive shaft down and disconnect it from the steering knuckle.
Installation
Installation in reverse order.
Note: The stabilizer struts, suspension arms and hub can only be screwed on when the dimension "a" between the center of the hub and the lower edge of the wheel arch has been established (position of the loaded mass)! Before installing the outer hinge, lightly lubricate its splines with mounting paste.
Cars with ground clearance sensor
Perform basic headlight installation.