Contents: Removal ⬇ Installation ⬇
Removal
1. Unscrew the fastening nut (1) and remove the ground wire from the housing, as shown in the figure below.
2. Disconnect the wiring harness connector (2) as shown in the figure below.
3. Remove the plastic cover and disconnect the wire (3) (terminal 30) from the pull-in winding.
Cars with manual transmission
4. Remove the soundproofing coating.
5. Loosen the fastening nut (1) and move the holder (2) together with the wiring harness to the side, as shown in the figure below. If necessary, disconnect the reversing light wiring harness connector (3), as shown in the figure below.
6. Loosen the gear shift lever fastening (if 02T).
7. Unscrew the mounting bolts (arrows) and remove the starter assembly (1), as shown in the figure below. Tightening torque of the mounting bolts during installation: 80 Nm.
Installation
1. Installation is carried out in the reverse order of removal.
Note: Always use new self-locking fastening nuts (1) and (3) after disassembly.
Tightening torques for fastening elements:
- (1) 20 Nm.
- (2) 16-20 Nm.
