Note.
- Necessary special devices, control and measuring devices and auxiliary means:
- Clamps for tubes 0 to 25 mm -MP7-602 (3094) -.
- Pliers for spring clamps.
- Container for collecting coolant.
Removing
1. Remove the lower protective casing of the engine compartment.
2. Disconnect the wiring harness connector (1), shown in the figure below.
3. Unscrew the fastening screw (3), remove the coolant circulation pump -V50- as shown in the illustration below.
4. Place a container for collecting coolant -VAS 6208- under the engine.
5. Clamping coolant hoses (2) Using special pipe clamps -MP7-601-, disconnect the hoses from the pump -V50- as shown in the figure below.
Installation
Installation is carried out in the reverse order of removal.
Tightening torque: 8 Nm.
Check the coolant level and, if necessary, add coolant to the system and remove air from it.