Contents: Removal and installation the…⬇ Installation ⬇
1. Attachment drive belt
2. Crankshaft pulley
3. Crankshaft pulley mounting bolt
4. Diamond coated washer
5. Cooling system water pump drive pulley mounting bolt tightening torque during installation 20 Nm
6. Pulley of the water pump drive of the cooling system
7. Engine cooling system water pump mounting bolt, tightening torque 9 Nm
8. Vacuum hose
9. Water pump of the engine cooling system
10. Generator assembly mounting bolt, tightening torque during installation 23 Nm
11. Alternator assembly
12. Fastening bolt. Tightening torque 25 Nm
13. Attachment drive belt tensioner
1. Attachment drive belt assembly
2. Crankshaft pulley mounting bolt
3. Crankshaft pulley
4. Diamond coated washer
5. Water pump pulley mounting bolt, tightening torque during installation 20 Nm
6. Pulley of the water pump drive of the cooling system
7. Water pump assembly mounting bolt, tightening torque during installation 9 Nm
8. Vacuum hose
9. Water pump assembly
10. Guide pulley, tightening torque of the mounting bolt during installation 40 Nm
11. Generator assembly mounting bolt, tightening torque during installation 25 Nm
12. Plastic lid
13. Mounting bracket for attachments
14. Alternator assembly
15. Mounting bracket fastening bolt, tightening torque during installation 40 Nm + tighten by 90°
16. Side mounting bracket fastening bolt, installation tightening torque 25 Nm
17. Air conditioning compressor assembly
18. Air conditioning compressor mounting bolt
19. Mounting sleeve
20. Mounting bracket for attachments
21. Tensioner of the accessory drive belt
Removal and installation the accessory drive belt
Removal
1. Remove the soundproofing coating.
Note: If the accessory drive belt is to be reused, an arrow indicating the direction of travel must be applied to its surface before removal.
Cars without air conditioning
2. Using an open-end wrench, loosen the tension on the accessory drive belt by moving the tensioner in the direction of the arrow, as shown in the figure below.
3. Lock the accessory drive belt tensioner using the special locking rod (T10060).
For cars with air conditioning system
4. Using a socket wrench, move the tensioner pulley in the direction of the arrow to release the tension of the accessory drive belt as shown in the figure below.
5. Lock the tensioner from moving by installing the special locking tool (T10060) (1), as shown in the figure below.
Continued for all cars
6. Remove the accessory drive belt assembly.
Installation
Note
- Before installing the accessory drive belt, make sure the alternator, air conditioning compressor and water pump are properly installed and secured.
- Be careful when installing the drive belt of the attachment, observe the direction of rotation of the belt.
1. Installation of the accessory drive belt begins with the crankshaft pulley, after which it is installed on the tensioner roller and then on the rest of the equipment.
2. Further installation is carried out in the reverse order of removal.
3. Start the engine and check the operation of the accessory drive belt.