Contents: Removal ⬇ Installation ⬇
1. Attachment drive belt
2. Crankshaft pulley mounting bolt
3. Crankshaft pulley
4. Spacer sleeve
5. Sealing ring
6. Guide roller, tightening torque of the mounting bolt during installation 42 Nm
7. Bolt for fastening the pulley of the water pump drive of the engine cooling system, tightening torque during installation 20 Nm
8. Pulley of the water pump drive of the engine cooling system
9. Cooling system water pump housing mounting bolt, tightening torque during installation 9 Nm
10. Water pump of the cooling system
11. Alternator mounting bolt, tightening torque during installation 25 Nm
12. Alternator assembly
13. Mounting bracket fastening bolt, tightening torque during installation 40 Nm + further tighten by 90°
14. Fastening bolt, tightening torque during installation 25 Nm
15. Mounting bracket for installing attachments
16. Tensioner of the accessory drive belt
17. Air conditioning compressor assembly
18. Air conditioning compressor mounting bolt, tightening torque 25 Nm
19. Mounting sleeve
20. Sealing cuff
Note.
- Necessary special devices, control and measuring instruments, as well as auxiliary means:
- Limiting bolt "T10060 A".
- Open-end wrench 16.
Removal
1. Remove the lower protective cover of the engine compartment.
2. Remove the lower part of the wheel arch liner on the right side.
Attention.
- If a used poly V-belt is installed in the opposite direction of travel, it may become unusable.
- Before you begin removing the poly V-belt, you should mark the direction of travel on it with chalk or a felt-tip pen for the purpose of reinstallation.
3. Fold back the tensioner with a 16 mm end wrench -in the direction of the arrow-, which will loosen the fastening of the poly V-belt.
4. Lock the tension element with the limiting bolt "T10060 A".
5. Remove the poly V-belt for the accessory drive.
Installation
Note.
- Before installing the poly V-belt, you need to ensure that all units are securely installed (alternator, air conditioning compressor, liquid cooling system pump).
- When installing a poly V-belt, ensure that it moves in the correct direction and that the belt is correctly installed on the pulleys.
1. First put the poly V-belt on the crankshaft pulley. Finally, put the belt on the tension roller.
Poly V-belt travel for vehicles without air conditioning:
1 - Liquid cooling system pump
2 - Poly V-belt tensioner
3 - Alternating current generator
4 - Poly V-belt
5 - Crankshaft
2. Further installation is carried out in the reverse order of actions than removal.
Original text is located on Skodabook.ru
3. Start the engine and check the running of the poly V-belt.
Poly V-belt running in cars with air conditioning
1 - Liquid cooling system pump
2 - Crankshaft
3 - Tensioner for poly V-belt
4 - Guide roller
5 - Alternating current generator
6 - Air conditioning compressor
7 - Poly V-belt