General form
1. Gearbox
2. Ball joint, 25 Nm
3. Oil seal for drive shaft
4. Guide sleeve
5. Retaining spring
6. 20 Nm
7. Clutch release lever
8. Clutch release bearing
9. Shutdown drive cylinder
10. Bolt tightening torque 20 Nm
11. Mounting bolt
Removal and installation
Removing
1. Disconnect the spring (arrow 1) up
2. Remove the clutch release fork (arrow 2) from the ball joint.
Installation
1. Install the spring first (arrow 1) on the clutch release fork as shown in the figure below.
2. Press in the clutch release fork (arrow 2) on the ball joint.
Removal and installation of release bearing
1. Pressing the latches (arrows) on the rear side of the clutch release lever, remove the clutch release bearing (A) from the clutch release fork as shown in the figure below.
2. When installing, push in the clutch release bearing (A) into the clutch release fork so that the latches (arrows) entered into a fixed position.