Contents: Removal ⬇ Installation ⬇
Removal
1. Remove the bracket with the clutch release hydraulic master cylinder.
2. Unlock the clutch pedal from the master cylinder of the clutch control booster using the T10005 pliers, as shown in the figure below.
3. Remove the clutch release master cylinder from the bracket.
Installation
1. Insert the clutch booster master cylinder into the bracket.
2. There should be a fastener (2) on the control rod (1) as shown in the figure below.
3. Press in the fastener (2) until it clicks into place in the recess on the clutch pedal (3), as shown in the figure below.
4. Install the bracket with the master cylinder of the hydraulic clutch release drive.
[Data Copied from the portal: www.skodabook.ru]