8.1 Cover fasteners behind the pedals
2. Pry off the plug with a screwdriver (4 to resist. illustrations) and unscrew the bolt located behind it (3).
8.2 Accelerator pedal installation details
3. Press tool T10238 into the grooves as far as it will go, as indicated on the resist. illustration, and remove the accelerator pedal module.
8.3 Removing the gas pedal
4. Disconnect the connector (2 in illustration 8.2) and remove the gas pedal assembly (5).
4. Mate the connector of the gas pedal module until it locks and slide it onto the mounting pins (6). Insert centering pin (7) into the hole in the floor, secure the accelerator pedal module with the bolt (3) with a force of 10 Nm and close it with a plug (4).
5. Install the shroud behind the pedals. If a new pedal module is installed, on models with DSG, the ECM must be adapted to it using a diagnostic tool.