Note: The steering column may remain built-in.
1. Disconnect the ground wire from the battery.
2. Set steering wheel 1 to the middle position (the car's wheels are set to move in a straight line).
3. Remove the steering wheel.
4. Remove Phillips head screws 2 and 3.
5. Remove covers 4 and 5 from the steering shaft.
6. Remove the panel of the protruding part of the floor between the front seats.
7. Using a screwdriver as a lever, remove cover 2.
8. Unscrew the Torx screws. There are screws in the blower nozzles (above and below) one screw each, accessible through the grille using a thin screwdriver with a Torx screw tip.
9. Remove the instrument panel cover 1.
10. Unscrew screws 1.
11. Remove the instrument panel 2 on both sides from the holders (indicated by an arrow).
12. Disconnect the plug connections.
13. Remove covers 1 and 3.
14. Unscrew the Torx screws.
15. Disassemble the light switch.
16. Remove the lower part of the instrument panel 2.
17. Unscrew the Torx screws.
18. Remove glove box 1.
19. Remove cover 1.
20. Unscrew the Torx screws.
21. Remove the middle part of the instrument panel 2.
22. Disconnect the plug connections.