1. Screw: Tightening torque: 1.5 Nm.
2. Screw: Tightening torque: 3.5 Nm
3. Front bumper
4. Screw: Tightening torque: 1.5 Nm.
Remove the front mudguard. Screw in screws "1" (1.5 Nm), Screw in screws "2" (3.5 Nm). Disconnect the headlight washer hose (if any). Disconnect existing electrical connectors (pedestrian protection system sensor). Press the locking hooks of the guide profile with a screwdriver inserted into the holes from above the "arrow". With the assistance of the 2nd mechanic, remove the front bumper "3" from the car in parallel.
RS Front Bumper
1. Decorative frame: Attached to the bumper with clips.
2. Bumper bracket
3. Bumpers
4. Left fog light
5. Grille on the left: Attached with clamps to the bumper.
6. Middle air intake grille: Attached with clamps to the bumper.
7. Adaptive cruise control unit air intake grille: fixed in the grille
8. Right fog light
9. Grille on the right: Attached with clamps to the bumper.
10. Bumper bracket