Front bumper (Skoda Fabia 5J)

Front bumper assembly diagram

• 1 - Front bumper

Partially remove the front wheel arch (fender) liner. Remove the screws (pos. 2). Remove the screws (pos. 3). Remove the bee rivets (pos. 6). Unscrew the screws (pos.5 and pos.7). Remove the bumper towards the front.

Important: Before removing the front bumper, you must disconnect the plug connectors for the fog lights, the plug connector for the electrical wires for the parking sensors and the headlight washer hoses (if they are part of the equipment).

Installation should be carried out in the reverse order of actions.

• 2 - 3.5 Nm
• 3 - 1 Nm
• 4 - Cover piece, left

The covering piece should be removed carefully using lever movements.

Installation

The cover piece should be pressed into the bumper clamps.

• 5 - 1.5 Nm
• 6 - Beekeeping rivet
• 7 - 1.5 Nm
• 8 - Cover piece, right

The covering piece should be removed carefully using lever movements.

Installation

The cover piece should be pressed into the bumper clamps.

• 9 - Cover, left
• 10 - Cover, right

Disassembling the front bumper

• 1 - 1.5 Nm
• 2 - Headlight washer
• 3 - Ventilation grille
• 4 - Bottom grille
• 5 - Headlight washer holder
• 6 - Fog light
• 7 - Jet housing
• 8 - Decorative grille

Using a suitable tool, remove the frame (pos. 9) using a lever motion (depending on the vehicle's equipment). Using a suitable tool, use a lever motion to remove the decorative grille from the bumper.

Installation

Press the decorative grille into the bumper clamps.

Press the frame into the bumper clamps (pos. 9).

• 9 - Frame (depending on the vehicle's equipment)
• 10 - Spoiler, lower
• 11 - Front bumper

Front bumper bracket assembly diagram

• 1 - Front bumper bracket

Remove the front bumper. Remove the air duct (pos. 5). Remove the screws (pos. 4). Remove the screws (pos. 2). Remove the front bumper bracket forward. Installation should be carried out in the reverse order of actions.

• 2 - 20 Nm
• 3 - Shock buffer
• 4 - 9 Nm
• 5 - Air duct