Removal and installation the support rod (Skoda Octavia 5E)

Support the hood. Turn the support rod "1" forward and remove it from the rubber bushing "2".

Installation

Insert support rod "1" into rubber bushing (pos. 2) "arrow a". Turn support rod towards front support panel "arrow b". Check holder "3" for damage, replace if necessary.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

◀ Previous

Skoda Octavia 3: Exterior (external elements)

Next ►

Removal and installation hood hinges
Removal and installation the pedestrian protection system loop
Removal and installation the hood actuator
Hood — design description
Removal and installation the rear tunnel crossmember

Parts and components of the hood locking mechanism
Removal and installation the hood lock
Removal and installation the hood release handle
Adjusting the hood
Trunk lid — design description

Read similar articles on other Skoda models

➧ Replacing the rubber-metal support Skoda Fabia 1 (1999-2007)
➧ Replacing the Teflon sealing ring and support ring on the fuel… Skoda Rapid 1 (2012-2022)
➧ Brake pedal support bracket — removal and installation Skoda Kodiaq 1 (2016-2024)
➧ Drum Brake Support Shield — Removal and Installation Skoda Favorit (1987-1994)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors

No comments yet

Octavia 3 (2013-2019)