Installing a rubber-metal support into a beam bracket
1 – protrusion on the support; 2 – mark on the bracket
The rubber-metal support can be replaced without removing the front suspension beam bracket from the vehicle.
1. Remove the front suspension arm from the vehicle (see subsection 7.2.4).
2. Using a puller, press the old support out of the bracket.
3. Press the new support into the bracket. In this case, protrusion 1 should coincide with mark 2 on the bracket.
(View the original on the website: «SkodaBook.ru»)
Caution! When pressing in, lubricate it only with G294 421 A1 grease. All other lubricants may cause damage to the bearing.
4. Install the front suspension arm onto the vehicle.