General installation diagram: rear axle transverse tie rod — front-wheel drive vehicles (Skoda Octavia 5E)

1. Subframe

2. Screw: Replace after each removal

3. Wheel hub bearing housing

4. Rear suspension tie rod

5. Bolt, 70 Nm and turn 180°: replace after each removal; always tighten threaded connections at the vehicle's own weight

6. Nut, 70 Nm and turn 180°: replace after each removal; always tighten threaded connections at the vehicle's own weight

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

◀ Previous

Skoda Octavia 3: Rear suspension

Next ►

Removal and installation the lower wishbone — all-wheel drive vehicles
Removal and installation the upper wishbone — all-wheel drive vehicles
General installation diagram: wishbone — all-wheel drive vehicles
Removal and installation the lower wishbone — front-wheel drive vehicles
Removal and installation the upper wishbone — front-wheel drive vehicles

Removal and installation the rear axle toe-in rod — front-wheel drive…
General installation diagram: rear axle transverse traction — all-wheel…
Removal and installation the trailing arm with support bracket
Parts and assemblies of the rear left ground clearance sensor «G76» —…
Details and assemblies of the rear left ground clearance sensor «G76» —…

Read similar articles on other Skoda models