Vehicles with rear left vehicle level sender -G76-
Release screws -2-. Remove rear left vehicle level sender -G76- -3- from control arm.
All
Remove suspension spring. Remove screw -2-.
Remove bolts -2- and -4-. Detach rear section of exhaust system and lower.
Mark the position of the eccentric screw -arrow- on the attachment bracket (e.g. felt-tip pen). Remove bolt -arrow-. Remove the lower transverse link.
Installation
Installation in reverse order.
Note: The tightening of the lower transverse link with screws may only be carried out if the prescribed distance is observed "A" between the center of the wheel hub and the lower edge of the wheel arch (in the position of the unladen weight of the vehicle).
Check wheel alignment.
Vehicles with ride height sensor
Carry out basic headlight setting.