Fabia Rapid Octavia Superb Kodiaq Yeti Others

Kodiaq 1 (2016-2024)

Disassembling and assembling the drive shaft — removing the roller bearing from the clutch housing (Skoda Kodiaq NS7)

0

When removing, squeeze the roller bearing retaining ring (arrow) with pliers (C) as shown in the figure below.

A. Kontropora (Kukko 22/2).; B. Puller with…

A. Kontropora (Kukko 22/2).; B. Puller with internal grip of 30...37 mm (Kukko 21/5)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Eleonora Afanasyeva

Skoda Kodiaq 1: Manual gearbox

Disassembly and assembly of the drive shaft — disassembly
Gearbox housing repair — hammering in the plug
Gearbox housing repair — removing the gearshift control shaft bushing
Gearbox housing repair — pressing the housing with the needle bearing (a)…
Gearbox housing repair — removing the housing with a needle bearing for…

Disassembling and assembling the drive shaft — pressing the roller bearing…
Disassembling and assembling the driven shaft (from 1st to 4th gear) —…
Pressing a disc into a driven shaft
Removal the outer race of a tapered roller bearing
Pressing the outer race of a tapered roller bearing into the clutch housing

Read similar articles on other Skoda models

➧ Disassembling and assembling the power steering gear housing Skoda Fabia 2 (2007-2014)
➧ Position for assembling bearing shells in connecting rods Skoda Rapid 1 (2012-2022)
➧ Disassembling and assembling the gearshift housing Skoda Octavia 1 (1996-2004)
➧ Bleeding the clutch hydraulic drive Skoda Superb 2 (2008-2015)
➧ Replacement of brake fluid, bleeding of the brake system and clutch… Skoda Yeti (2009-2017)
➧ Checking, removing, installing, disassembling and assembling the… Skoda Felicia (1994-2001)

Link to this article in various formats

TEXTHTMLBB Code

Reviews and comments of visitors

No comments yet

Kodiaq 1 (2016-2024)

By continuing to use the site, you agree to the use of cookies.