1. Poly V-belt: check the degree of wear; before removing, mark the direction of the belt with chalk or a felt-tip pen; don't overdo it; when installing, ensure that the position on the pulleys is correct
2. 10 Nm and turn 90° (¼ turn): replace after disassembly; use only original bolts
3. Crankshaft pulley: with torsional vibration damper; installation position: the hole in the damper must be located above the projection of the toothed pulley of the crankshaft
4. Poly V-belt tensioner
5. 20 Nm and turn 90° (¼ turn): replace after disassembly
6. Bolt
7. Bolt
8. Roller damper
9. Centering sleeve: ensure correct position in the hole of the bracket of the mounted units
10. Mounted unit bracket
11. High pressure fuel pump
12. Generator
13. Bolt
14. Bolt
15. Centering sleeve: ensure correct position in the holes of the air conditioning compressor
16. Air conditioning compressor
17. Bolt
Torque and sequence of tightening the bracket of mounted units
Note: Replace screws that are tightened to the specified angle.
Use the following bolts: screws -1, 2, 3, 6- M10x35, screw "4" M10x115, screw "5" M10x175. Tighten the bolts in stages in the specified sequence.
