Attention! Bulbs H7 and H15 are under pressure and may burst when replaced. It is recommended to wear gloves and goggles when replacing lamps. When installing an incandescent lamp, do not touch the glass bulb. Your fingers may leave grease marks on the bulb, which, when the incandescent lamp is turned on, evaporate and cause the bulb to become cloudy. Pay attention to the correct position and the absence of damage to the seals on the plastic covers. Water ingress can damage the headlights.
Replacing the low beam bulb H7
Switch off the ignition and all electrical consumers. Remove cover -1-.
By swinging and pulling out, release the bulb -2- from the retainers -arrows- and remove it. Disconnect connector -1-.
Installation in reverse order.
Replacing the H15 multifunction lamp (for high beam, front running light and position light)
Switch off the ignition and all electrical consumers. Remove cover -2-. Turn bulb -1- to left -arrow- and remove from headlight housing.
Installation in reverse order.
PWY24W turn signal bulb replacement
Note: To replace the turn signal bulb, a repair kit is supplied - bulb, O-ring, protective cap and fixing screws.
Switch off the ignition and all electrical consumers. Remove the headlight with the defective incandescent bulb. Lever out turn signal lens -1- with a screwdriver and remove. Be careful not to get the remains of the casing into the headlight housing. Turn the bulb holder -arrow- out of the headlight and remove it. Disconnect connector -2- and replace defective bulb.
After installing a new incandescent lamp -4-, fix the protective cap -2- with the sealing ring -3- with screws -1- (1.5 Nm).
Installation in reverse order.