Removing and installing discharge lamp control unit -J343- for left or -J344- for right headlight
Remove headlight. Remove screws -arrows- (1.4 Nm) and remove control unit -1-. Unlock and disconnect connectors.
Installation
Installation in reverse order.
Note: When installing the unit, place the seal correctly, water penetrating inside can cause destruction of the headlight.
Removing and installing headlight control unit -J667- for left or -J668- for right headlight
Remove headlight. Remove screws -2- (1.4 Nm) and remove control unit -1-. Unlock and disconnect the connector.
Installation
Installation in reverse order.
Note: When installing the unit, place the seal correctly, water penetrating inside can cause the headlight to break.
Removing and installing daytime running lights and position light control unit -J860- (led module) left or -J861- right
On the left side, remove the headlight. On the right side, remove the right front fender liner. Remove screws -3- (1.4 Nm) and remove control unit -4-.
Installation
Installation in reverse order.
Note: When installing the unit, place the seal correctly, water penetrating inside can cause the headlight to break.
Removing and installing cornering light and headlight range adjustment control unit -J745-
The control unit is located above the brake pedal.
Note: If the control unit is to be replaced, connect the Tester and "Guided Fault Finding" select function "Replacing the control unit" for the respective control unit.
Switch off the ignition and all electrical consumers. Remove the leg airbag. Remove the deflector in the footwell on the driver's side. Remove the brake pedal support bracket. Pull out the pin and remove the spacer sleeve -3-. Lower block -1- down, unlock and disconnect connector -2-.
Installation in reverse order.