Contents: General information ⬇ Headlights ⬇
General information
If any incandescent lamps fail, pay attention to the following points:
- a) Before starting the replacement, disconnect the negative battery cable (see note in Section General information and precautions);
- b) Remember that a lamp that has just been lit remains very hot for some time;
- c) Try not to touch the bulb with bare fingers and do not leave greasy stains on it, which will cause a decrease in the brightness of the glow and a gradual dimming of the reflector;
- d) Check the quality of the electrical contact between the lamp base and the terminals of its socket. Before installing a new lamp, clean the terminals from traces of corrosion. In bayonet-type lamps, make sure that the socket contacts are pressed tightly against the base terminals;
- e) Ensure that the replacement lamp matches the electrical characteristics of the faulty one.
Headlights
1. Turn the access cover counterclockwise and remove it from the rear of the headlight assembly.
2. Disconnect the electrical wiring from the lamp.
3. Release the clips and remove the bulb with the socket from the rear of the headlight. Remove the bulb from the socket.
Material is available on the website: Skodabook.ru
4. Try not to touch the bulb of the new lamp with bare fingers - use a paper towel or napkin. Remove any accidentally left stains by wiping the bulb with methyl alcohol.
5. Install the new lamp, making sure that the assembly is seated correctly in the headlight.
6. Connect the electrical wiring and install the access cover (with the "TOP" mark facing up).