1. Connecting fitting
2. O-ring: replace; lubricate coolant
3. Landing pin.
4. 9 Nm
5. Gasket: replace
6. Coolant pump: remove the protective cap from the new coolant pump
7.9 Nm
8. Toothed belt: coolant pump drive
9.9 Nm
10. Toothed belt guard
11. 10 Nm and tighten by 90: (¼ vol.): left hand thread; replace
12. Drive pulley: install in proper position
13. O-ring of the balancer shaft of the intake camshaft: replace
14. Balance shaft
15. Gasket: replace
16. Thermostat actuator -N493-
Tightening sequence for thermostatic actuator screws -N493-
Tighten screws in sequence -1...5-.
The tightening sequence of the cooling pump mounting screws
Tighten screws in sequence -1...4-.