Remove vent -1- in footwell on driver's side.
Remove data bus diagnostic interface -J533- -1- from holder and place to one side.
Unscrew screw -2-, detach impact protection strut -1- and move to one side.
Press locking pins -arrows- together and pull bearing pin -1- of clutch master cylinder pusher to right.
Move clutch pedal in direction of -arrow-, disconnect and remove top dead center spring -1-.
Installation
Installation in reverse order. Connect the push rod of the clutch master cylinder to the clutch pedal using a new support axle. Install impact brace -1- and tighten screw -2-. Install data bus diagnostic interface -J533-. Install the deflector in the footwell on the driver's side. Install the driver's knee airbag, if removed. Connect battery.
Removal and installation of tension spring and top dead center spring
Disconnect battery wire to ground. If fitted, remove knee airbag -1- for driver. Remove vent -1- in footwell on driver's side. Remove data bus diagnostic interface -J533- -1- from holder and place to one side. Unscrew screw -2-, detach impact protection strut -1- and move to one side. Press locking pins -arrows- together and pull bearing pin -1- of clutch master cylinder pusher to right. If fitted, unhook and remove tension spring -1-; to do this, pull clutch pedal in direction of -arrow A-. Pull the clutch pedal in the direction -arrow A-, unhook and remove the top dead center spring -2-.
Installation
Installation in reverse order. The support bushes -arrows- of the pins -1- are installed. Move clutch pedal in direction -arrow A- towards passenger compartment. Insert pin -1- into socket -2- of bracket. Insert support -3- into socket -4- of clutch pedal. Press the clutch pedal in the direction -arrow B- so that the top dead center spring pops out towards the bracket. Connect the push rod of the clutch master cylinder to the clutch pedal using a new support axle.
Install impact brace -1- and tighten screw -2-. Install data bus diagnostic interface -J533-. Install the deflector in the footwell on the driver's side. Install the driver's knee airbag, if removed. Connect battery.