1. Hex head screw
2. Bleed nipple, 4.5 Nm
3. Rubber cap
4. Hose for work after switching off
5. Hydraulic brake fluid reservoir
6. Seal: Must be in the hose for operation after shutdown
7. Clutch master cylinder
8. Clamp: To remove and install the hose line, pull the clamp out until it stops
9. O-ring/O-ring seal: Replace if damaged; put on the nipple; installed together with the brake fluid. O-rings/O-rings of circular cross-section are selected in accordance with the design of the pipeline fitting
10. Holder: pipe hose
11. Pipeline and hose
12. O-ring/O-ring seal: Replace if damaged; put on the nipple; installed together with the brake fluid. O-rings/O-rings of circular cross-section are selected in accordance with the design of the pipeline fitting
13. Clamp: to remove and install the hose line, pull the clamp out until it stops
14. Slave cylinder