Side impact sensor on the rear body pillar — removal and installation (Skoda Rapid NH1)

Contents: Removal ⬇ Installation ⬇

Warning. Do not connect electrified measuring devices to the airbag terminals. This may cause spontaneous activation of the squib and, as a result, serious injuries.

Note. Repair of the passive safety system components is not provided. In case of failure, the damaged component is replaced as an assembly.

Attention: Before starting any work, turn off the ignition and disconnect the negative terminal from the battery, then wait at least 3 minutes.

Attention.

The impact sensor must always be replaced after the airbags have been deployed.

Replace the shock sensor if it has fallen.

Attention.

Always replace the fastening nuts after disassembly and assembly.

Be extremely careful when installing the sensor to avoid damaging its wiring harness.

Attention. Always tighten bolts and nuts securing the passive safety system components to the specified tightening torque. Failure to follow this instruction may result in incorrect operation of the entire safety system assembly.

Note: Check and ensure that the contact surfaces on the shock sensor and support are clean.

Note: Mark the location of the side projection on the shock sensor for proper installation.

Removal

1. Disconnect the negative terminal from the battery.

2. Remove the rear wheel arch liner (see the corresponding section in the chapter Body).

3. Disconnect the wiring harness connector (3) shown in the figure below.

4. Loosen the mounting screw (1) and remove the side impact sensor assembly (2) as shown in the figure below. Tightening torque of the mounting screw during installation: 9 Nm.