Contents: Installation ⬇ Tightening torque ⬇
Important: Removal and installation of the speed sensor is carried out in the same way on vehicles with drum brakes as with disc brakes. An image of a speed sensor on a vehicle with disc brakes is used.
Raise the car. Disconnect the plug connector "1" of the speed sensor wire from the speed sensor. Unscrew the hex socket bolt "2". Remove the speed sensor from the axle stub (journal) and brake shield.
Installation
After installing the speed sensor into the hole in the axle journal (neck), tighten the Allen screw "2". Connect the plug connector "1" of the speed sensor wire and the speed sensor.
Tightening torque
| Speed sensor screw | 8 Nm |
[Information presented on the website: SKODABOOK.ru]