Contents: Installation ⬇ Tightening torque ⬇
Raise the vehicle. Disconnect the speed sensor connector "1"/speed sensor wire. Remove screw "2" from the wheel hub bearing housing. Remove the ABS speed sensor from the wheel hub bearing housing.
Installation
Before installing the speed sensor, clean the inner surface of the hole and lubricate the speed sensor along the entire perimeter with heat-resistant paste for threads "G 052 112 AZ". Insert the speed sensor into the hole of the wheel hub bearing housing and tighten the screw. Connect the connector to the speed sensor.
Tightening torque
Article reprinted from the website www.SKODABOOK.ru