Contents: Disassembly ⬇ Assembly ⬇
Attention! If there are other protective pads on the body, the new glued pad must be aligned in such a way that it fits well with the existing pads.
1 – front door protective trim (self-adhesive);
2 – rear door protective trim (self-adhesive)
Disassembly
Heat the self-adhesive protective cover with hot air from a plastic welding machine (e.g., "\/.A.G. 1416") and remove the cover.
(Article published on the website: www.SkodaBook.ru)
Assembly
1. Clean the corresponding area of the body to be glued with gasoline and then thoroughly degrease with silicone remover and dry the corresponding area on the body.
2. Mark the position of the protective strip on the body:
- a = 205 mm;
- b = 237 mm
3. After removing the protective film, lightly grab the protective pad and then press it firmly (before you start pressing, you should make sure that there has been no change in position). It is good that the temperature of the protective lining and the outer sheet metal of the body is about 40°C