Parts and assemblies of ABS speed sensors on the front axle (Skoda Octavia 5E)

1. ABS speed sensor: before replacing the sensor, clean the inner surface of the hole and lubricate with heat-resistant thread paste "G 052112 AZ"

2. Bolt, 8 Nm

3. Wheel hub with wheel hub bearing: The ABS sensor toothed disc is built into the wheel hub bearing

4. Pitch shaft

(Article reprinted from the website: SKODABOOK.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

◀ Previous

Skoda Octavia 3: Brake system

Next ►

Removal and installation the hydraulic unit bracket
Removal and installation of the ECU and hydraulic unit
Parts and components of the hydraulic unit, brake booster
Parts and components — ABS/ESC

Removal and installation the ABS speed sensor on the front axle
ABS speed sensor components and assemblies on the rear axle
Removal and installation the ABS speed sensor on the rear axle
Replacing Front Brake Pads — Installation Instructions
Front brake repair, brake caliper PC 57

Read similar articles on other Skoda models