ABS speed sensor components and assemblies on the rear axle (Skoda Octavia 5E)

1. ABS speed sensor: before replacing the sensor, clean the inner surface of the hole and lubricate with heat-resistant thread paste "G 052 112 AZ"

2. Bolt, 8 Nm

3. Wheel hub with wheel hub bearing: The ABS sensor toothed disc is built into the wheel hub bearing

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article verified: Anatoly Ovchinnikov

◀ Previous

Skoda Octavia 3: Brake system

Next ►

Removal and installation the ABS speed sensor on the front axle
Parts and assemblies of ABS speed sensors on the front axle
Removal and installation the hydraulic unit bracket
Removal and installation of the ECU and hydraulic unit
Parts and components of the hydraulic unit, brake booster

Removal and installation the ABS speed sensor on the rear axle
Replacing Front Brake Pads — Installation Instructions
Front brake repair, brake caliper PC 57
Removal and installation of brake pads of the brake mechanism PC 57
Removal and installation the brake caliper PC 57

Read similar articles on other Skoda models