Instrument cluster
Component Protection
The message SAFE СР on the display in the instrument cluster means that the protection of the instrument cluster is activated.
Fault indicator
If there is a fault in the instrument cluster, the following message is shown on the display: «M» Error: instrument cluster. In repair! «S» INSTRUMENT COMBINATION FOR REPAIR.
Contact the service station.
Instrument cluster
1. Tachometer with control lamps
2. Display: with a mileage counter, with a service indicator, with an electronic clock, with an information system, with control pictograms
3. Speedometer (1) with control lamps
4. Coolant temperature gauge
5. Panel with control lamps
6. Key for: setting the hours / minutes, displaying the mileage and time remaining until the next maintenance, resetting the maintenance indicator, resetting the daily mileage counter, indicating the battery charge
7. Fuel gauge
Tachometer
The red color on the scale of the tachometer 1 marks the zone in which the control system begins to limit the engine speed. The system automatically limits engine speed to a safe limit. Shift to a higher gear or move the automatic transmission selector to position D before the tachometer needle reaches the red zone. To prevent the engine from running at too high or too low speeds, it is necessary to follow the recommendations for choosing a gear.
Display types
The instrument cluster may have a display of one of the listed types.
A. Segment display
B. MAXI DOT display
Note. Depending on the vehicle equipment, the MAXI DOT display can be monochrome («black and white») or colored.
Speedometer
Speed Warning
If the speed exceeds 120 km/h, a warning sound signal sounds. When the speed drops below 120 km/h again, the warning sound will turn off.
Coolant temperature gauge
The coolant temperature gauge only works when the ignition is on.
Low temperature zone
If the arrow is in the left zone of the scale, the engine has not yet reached operating temperature. Avoid high revs, driving with the accelerator pedal fully depressed, and excessive load on the engine. This prevents the risk of engine damage.
Working temperature zone
If the pointer is in the middle zone of the scale, the engine has reached its operating temperature. If the engine load is high or the outside temperature is high, the needle may move further to the right.
High temperature zone
If the arrow reaches the red sector of the scale, the coolant temperature is too high.
Fuel gauge
The fuel gauge works only when the ignition is on. The volume of the fuel tank is about 50 liters. When the amount of fuel in the tank drops to the reserve level (the indicator needle reaches the red area of the scale), the control icon lights up.
Carefully! Never continue driving until the fuel tank is completely empty! Cylinder misfires can occur due to interruptions in the fuel supply. This can cause serious damage to engine parts and exhaust system. After full filling of the fuel tank in dynamic driving (e.g. when making frequent turns, braking, going up and downhill) The fuel gauge may indicate a level approximately one bar below the actual level. After a stop or with a smoother movement, the gauge will again show the actual fuel level. This feature is not a malfunction.
The arrow next to the symbol in the fuel gauge indicates the location of the fuel filler neck - on the right side of the vehicle.
Odometers
Segment display/MAXI DOT display
Trip counter [trip]
The daily mileage counter A shows the distance traveled by the vehicle since the last reset of the counter, the readings are displayed with an accuracy of 100 m.
Reset trip odometer
Briefly press key 6.
Total mileage counter
The total mileage counter B displays the total distance traveled by the vehicle.
Clock setting
Turn on the ignition. Keep key 6 pressed until the hour appears on the display. Release key 6 - the system switches to the time setting function. Press key 6 again and set the hour. Wait about 4 seconds, the system will switch to setting the value for minutes. Press the 6 key again and set the minutes. The clock can also be set in the Infotainment system.
Battery charge indication
Switch off the ignition. Keep key 6 pressed until the display shows Battery Status or Battery SOC. Release the key 6, the percentage of battery capacity will be displayed (%).
Self-diagnosis
When the ignition is switched on in the vehicle, certain functions and statuses of individual vehicle systems are constantly checked. Error messages and other data are shown on the display in the instrument cluster. Some messages are shown at the same time as warning lamps or pictograms on the display. Messages are displayed until the problem is corrected. After the first display, the characters or continue to be displayed without prompting the driver.
Pilot lamps
The indicator lamps show the current status of functions or faults. The lighting of some warning lamps may be accompanied by audible signals and the appearance of messages on the display in the instrument cluster. After switching on the ignition, some control lamps light up for a short time to check the operability of the vehicle systems. If the systems are in good order, a few seconds after the ignition is switched on, the control lamp goes out. The current status of functions and systems is indicated by control icons on the display. The control lamps are located in the following places in the instrument cluster: tachometer 1, speedometer 3, panel with control lamps 5.
Attention! Ignoring warning lights and messages on the instrument cluster display can result in personal injury and damage to the vehicle. If you are forced to stop due to a technical problem, stop the vehicle at a safe distance from the traffic flow, turn off the engine and turn on the hazard warning lights. The warning triangle must be set at the prescribed distance. The engine compartment of a car is a zone of increased danger.
AKP
The control lamps report a malfunction / condition of the automatic transmission.
Parking brake
The control lamp burns at the tightened parking brake. When driving with the parking brake applied at speeds above 5 km/h, an audible signal sounds. The instrument cluster display shows the following message: «M» Release the parking brake! «S» DISENGAGE PARKING BRAKE.
Brake system
When the warning light is on, it means that the brake fluid level is very low. The instrument cluster display shows the following message: «M» Torm. liquid! «S» CHECK BRAKE FLUID.
Stop the car, turn off the engine and check the brake fluid level. If the warning lamp lights up together with the warning lamp, this means that there is a malfunction in the ABS system.
If counter. the lamp lights up together with the counter. lamp, do not continue driving! Contact the service station. A failure in the operation of the brake system can significantly lengthen the stopping distance of the vehicle!
Warning lamp for not wearing a seat belt
The warning lamp lights up when the ignition is switched on, as a reminder of the need to buckle up the driver and front passenger. The indicator lamp goes out only when the driver and (or) the front passenger has their seat belts fastened. The warning light flashes and an audible warning sounds at the same time if the driver or front passenger has not fastened their seat belt and the vehicle speed is above 30 km/h. If the driver or front passenger does not fasten the seat belt for about 2 minutes, the horn stops and the warning light stops flashing and stays on.
Power steering
If the warning light comes on, there is a partial power steering failure and more force may be required to turn the steering wheel. Contact a service station immediately. When the warning light is on, the power steering is completely out of order and there is no steering assist (much more force is required to turn the steering wheel). Contact a service station immediately.
Note: When disconnecting and reconnecting the battery, after turning on the ignition, the contr. lamp.
After the vehicle has traveled a short distance, the warning lamp should go out. If the warning light does not go out after restarting the engine and a short drive, the system is faulty. Contact a service station immediately.
Anti-slip system (ASR)
If your vehicle is equipped with an ESC system, the ASH traction control system is integrated into the ESC system. When the warning lamp flashes, the ASR system is activated. If the control lamp burns, the ASR system is faulty. The instrument cluster display shows the following message: «M» Error: traction control, «S» ASR ERROR.
Contact a service station immediately. If the warning light comes on immediately after starting the engine, the ASR system may be disabled for technical reasons. Switch the ignition off and on again. If the warning light does not come on after restarting the engine, the ASR system is fully operational again.
Note: If the battery was disconnected and reconnected, then after turning on the ignition, the counter lights up. lamp. If, after the vehicle has driven a short distance, the control lamp does not go out, the system is faulty, contact a service station immediately.
Anti-slip system (ASR) off
If the control lamp is on, this means that the ASR system is turned off. The instrument cluster display shows the following message; «M» Antiprobuksov. system (ASR) off. «S» ASR OFF
Stability Program (ESC)
When the indicator lamp flashes, this means that the ESC system is working. If the control lamp is on, the ESC system is faulty. The instrument cluster display shows the following message: «M» Error: ESC (syst, support, courses, stable.). «5» ESC ERROR.
Contact a service station immediately. If the warning light comes on immediately after starting the engine, the ESC system may be disabled for technical reasons. Switch the ignition off and on again. If the warning light does not come on after restarting the engine, the ESC system is fully operational again.
Note: If the battery has been disconnected and reconnected, the warning light comes on after the ignition is switched on. If, after the vehicle has driven a short distance, the warning lamp does not go out, the system is faulty. Contact a service station immediately.
Anti-lock braking system (ABS)
If the control lamp burns, the ABS system is faulty. The instrument cluster display shows the following message: «M» Error: ABS. «S». ABS ERROR.
The car is braked only by the brake system, without the participation of the ABS system. Contact a service station immediately.
If the control lamp lights up together with the control lamp, do not continue driving. Contact the service station. Failure of the ABS system or the brake system can significantly lengthen the braking distance of the vehicle!
Rear fog lamp
The control lamp lights up when the rear fog lamp is on.
Exhaust gas monitoring system
If the warning lamp is on, the exhaust gas monitoring system is faulty. The system allows movement in emergency mode. Contact a service station immediately.
Pre-glow system (diesel engine)
The control lamp lights up after inclusion of ignition. After the lamp goes out, the engine can be started immediately. If the control lamp does not light up or burns constantly, the preglow system is faulty. If the warning lamp flashes while driving, there is a problem with the engine management system. The system allows movement in emergency mode. Contact a service station immediately.
Electronic gas pedal (Gas engine)
If the EPC warning light is on, there is a problem with the engine management system. The system allows movement in emergency mode. Contact a service station immediately.
Security systems
Faults in the airbag system
If the warning lamp is on and the following message appears on the display, the airbag system is defective; «M» Error: airbag. «S» PILLOW ERROR SAFETY.
The readiness of the airbag system is controlled automatically, even when one of the airbags is deactivated.
Airbag or seat belt pretensioner deactivated using tester
When the ignition is switched on, the control lamp lights up for 4 seconds and then flashes for about 12 seconds. The instrument cluster display shows the following message: «M» Cushion without./pretensioner disabled. «S» AIRBAGS/PRESENT, vyp.
Front passenger airbag deactivated with key switch
The control lamp burns after inclusion of ignition within 4 seconds. The OFF indicator lamp in the PASSENGER AIR BAG ON / OFF inscription in the central part of the front panel lights up after the ignition is turned on.
Preventive security system
If the warning lamp is on and one of the following messages appears on the display, the driver's and front passenger's seat belts need to be replaced. Immediately contact the service station: «M» The preventive security system is not available. «5» PREVENTIVE PASSIVE SAFETY IS NOT AVAILABLE or «M» Preventive security system: work with restrictions. «S» PREVENT. SAFETY SYSTEM LIMITED OPERATION
Tire pressure
The warning lamp comes on if a significant drop in pressure is detected in one of the wheels compared to the original value. Check the pressure in all tires and top up if necessary. In addition, a warning sound signal is also heard. If the control lamp flashes, there is a malfunction in the system. Contact a service station immediately.
Note: When disconnecting and reconnecting the battery, after turning on the ignition, the control lamp is on.
If, after the vehicle has driven a short distance, the warning lamp does not go out, the system is faulty. Contact a service station immediately.
Brake pads
When the warning light is on, the brake pads are worn out. The instrument cluster display shows the following message: «M» Check your brake pads! «8» CHECK BRAKE PADS.
Contact a service station immediately.
Lane assist (Lane Assist)
The indicator lamps indicate the status of the Lane Assist system.
Direction indicators
Depending on the position of the turn signal switch, the left or right indicator lamp flashes. If there is a malfunction in the direction indicators, the control lamp flashes at a double frequency. This does not apply to vehicles with a trailer. When the hazard warning light is on, all direction indicators of the vehicle, as well as both control lamps, flash simultaneously.
Direction indicators on a trailer
When the indicator lamp flashes, this means that the direction indicators on the trailer are on. When a trailer is hitched and the warning light does not flash, one of the trailer's turn signals is defective. The instrument cluster display shows, for example, the following message: «M» Trailer: prov. turn signal on the left! «S» CHECK LION. DECREE. TRAILER SWING.
The trailer must be connected properly.
Fog lights
The control lamp burns at the included antifog headlights.
Cruise control
The control lamp lights up when the cruise control is on.
Selector lever lock
If the control lamp lights up, press a brake pedal.
High beam
The control lamp burns at the included main beam or a light signal.