Dividing grid (Combi) (Skoda Octavia 5E)

Using the dividing net behind the rear seats

Folding out part of the luggage compartment cover/dividing net behind the rear seats in a stretched state

Dividing grid: release lever

Unwinding

Unfold the roll-up luggage compartment cover section A in the direction of the arrow. Pull the partition net by the upper crossbar B out of the housing C. Hook the crossbar into the socket D on one side. Press the crossbar on the other side and hook this side into the socket D. When the crossbar is, for example, in the left socket D, press it on the other side in the direction of arrow 1 and insert it into the right socket D. Fold the roll-up luggage compartment cover section A in the direction opposite to the arrow.

Article posted on the website: SkodaBook.ru

Winding up

Unfold the section of the roll-up luggage compartment cover A in the direction of the arrow. Press the crossbar and remove it from the sockets D first on one side and then on the other. To avoid damaging the separating net when rolling it up in the body C, hold it by the crossbar B. Fold the section of the roll-up luggage compartment cover A in the direction opposite to the arrow.

Caution! If the separating mesh gets stuck when pulling it out of the housing, press the release lever E in the direction of the arrow.

Using the divider net behind the front seats

Rear Seats: Removing the Divider Net Housing

Unwinding

Fold the rear seat forward. Pull the partition net by the upper crossbar A out of the housing B. Hook the crossbar into the socket C on one side. Press the crossbar on the other side and hook this side into the socket C. When the crossbar is in, for example, the left socket C, press it on the other side in the direction of arrow 1 and insert it into the right socket C.

Winding up

Press the crossbar and remove it from the sockets C first on one side and then on the other. To avoid damaging the partition net when rolling it up in the body B, hold it by the crossbar A. Return the rear seat to its original position.

Removal and installation the divider mesh housing

Rear Seats: Removing the Divider Net Housing

Fold the rear seat forward. Open the right rear door. Slide the housing of the partition net A in the direction of arrow 1 and remove it from the fastenings on the backrests of the rear seats in the direction of arrow 2.

Installation

Insert the notches of the partition net housing into the fastenings in the rear seat backs. Slide the partition net housing against the direction of arrow 1 until it stops. Return the rear seat to its original position.