Seat functions (Skoda Octavia 5E)

Heated seats: front/rear

The backrests and cushions of the front seats, as well as both outer rear seats, can be equipped with electrical heating. The seat heating can only be used when the engine is running.

Turning on

Press the key or .

This material is published on the portal [www.skodabook.ru]

A single press switches on the maximum heating intensity - stage 3. This is indicated by three illuminated counter lamps under the corresponding key. Subsequent presses of the key reduce the heating power until it is switched off. The switched on heating power is shown by the number of indicators lit under the key or in the key.

Note: If the vehicle's voltage drops, the seat heating will automatically switch off to ensure sufficient power supply for engine control.

Front armrest

Armrest adjustment

The armrest is adjustable in height and longitudinally.

Height adjustment

First close the lid and then lift it in the direction of arrow 1 to one of the four fixed positions.

Moving

Slide the cover in the direction of arrow 2 to the desired position. There is a storage compartment under the armrest.

Note: Before using the parking brake, move the armrest cover back as far as it will go.

Rear armrest

Lowering the armrest

Flipping back

Pull the loop A and fold the armrest in the direction of the arrow. There may be a cup holder in the armrest.

Folding the front passenger seat back

The front passenger seat backrest can be folded forward to a horizontal position.

Flipping back

Pull the lever in the direction of arrow 1. Lower the backrest forward in the direction of arrow 2. You should hear a click when it locks.

Return to the starting position

Pull the lever in the direction of arrow 1. Raise the backrest in the opposite direction to arrow 2. You should hear a click when it locks into place.

Rear seat backs

Seat back: unlock/lock

Luggage compartment: folding rear seat back (Octavia/Combi)

By folding the seat back, you can increase the capacity of the trunk. In cars with separate rear seats, if necessary, you can fold the seat backs separately.

Folding

Before folding the rear seatbacks, adjust the position of the front seats so that they will not be damaged when folding the rear seatbacks (1). Press the locking handle A and fold the seatback completely.

Folding from the trunk

The rear seat backs can be unfastened from the trunk and folded forward. On the right side of the trunk is a lever for unlocking the right and middle parts of the rear seat backs. On the left side of the trunk is a lever for unlocking the left rear seat back. Pull the corresponding lever in the direction of the arrow. When unlocked, each of the rear seat backs can be folded forward.

Return to the starting position

Hold the rear outer seat belt C against the side panel trim. Then tilt the seat back backwards until the locking handle A clicks into place. Check that the locking is done by pulling the seat back forward. Make sure that the red pin B is completely hidden.

Under no circumstances should the seat belts be allowed to become trapped by the seat backs raised to their original position. In vehicles with a partition net, first unlock the left, then the right and middle parts of the seat back (2).

(1) If the front seats are positioned too far back, we recommend that you remove the rear head restraints before folding the seatbacks. Store the removed head restraints in a manner that will prevent them from becoming damaged or dirty,

(2) For Combi vehicles.