1. Timing belt: Before removing, mark the direction of the belt with chalk or a felt-tip pen; check for wear
2. 25 Nm
3. Tension roller: when removing and installing, remove the engine support bracket 47 Nm
5. Filler cap
6. 50 Nm and turn further by 135° (3/8 rev): replace
7. Exhaust camshaft toothed pulley: with valve timing adjuster
8. Washer
9. Centering sleeve
10. Intake camshaft toothed pulley: with valve timing adjuster
11. 50 Nm and turn further by 135° (3/8 turn): replace
12. O-ring: replace
13. Threaded plug, 20 Nm
14. Spacer sleeve: with O-ring seal; replace the sealing ring
15. Guide roller
16. 40 Nm
17. Crankshaft toothed pulley: there should be no oil on the mating surfaces of the pulley and crankshaft; installation is possible only in one position
Tightening torque of the threaded plug / hole "TDC" in the cylinder block
Note: Replace damaged sealing ring.
Tighten the threaded plug "arrow" to a torque of 30 Nm.