Removal and installation of engine mounts
Disconnect connector -1-. Detach hose -2- from canister. Lever out retainers with a screwdriver -arrow- and move coolant expansion tank to one side. Remove the wiper arms. Remove the plenum box cover. Remove the caps on the threaded connections of the cups of the front shock absorber struts. Install adapter -MP9-200/18 (10-222A/18) - with hook for MP9-200 and T30099 -MP9 -200/10 (10-222A/10) - and support -10-222A/31-3-.
Position crosshead -T30099- with support -10-222A/31- and support -T30119- on the screw connections of the front suspension strut cups. Slightly tighten the power unit with the spindle, but do not lift.
Remove bolts -arrows- and engine support -1-.
Installation
Installation in reverse order. Checking the adjustment of the power unit supports.
Removal and installation of gearbox supports
Remove the plenum box cover. Remove engine cover. Loosen clamps -1, 2- and remove air duct. Remove the air filter housing. Remove the battery and its bracket. Remove the engine control unit.
Unscrew nuts -arrows- and remove bracket -1-.
Note: Depending on the version, the brackets may vary.
Pivot cable mounts -1- upwards, disengaging them from retainers -arrows- and press to one side. Remove the wiper arms. Remove the plenum box cover. Remove the caps on the threaded connections of the cups of the front shock absorber struts. Install adapter -MP9-200/18 (10-222A/18) - with hook for MP9-200 and Т30099 -MP9-200/10 (10-222A/10) -and support-10-222А/31-3-.
Position crosshead -T30099- with support -10-222A/31- and support T30119- on the threaded connections of the front suspension strut cups. Install the lead screw carabiner on the motor lug. Tighten the power unit with the lead screw, but do not lift.
Remove screws -arrows- and remove gearbox bracket -1-.
Installation
Installation in reverse order.
Note: Replace screws that are tightened to the specified angle. Risk of damage to the threads in the gearbox bracket due to misalignment of the bolts. Before screwing in the screws -arrows 1-, the bracket for the gearbox and the bracket for the gearbox support must be absolutely parallel to each other. If necessary, to do this, raise the gearbox at the rear with a jack. Do not remove support bracket -T30099- until all screw connections of power unit support have been tightened to the specified torque.
Raise the gearbox with the help of the spindles of the crosshead so that the gearbox console comes into contact with the bracket of the gearbox support. Check the position of the power unit supports.